p295gh material standard elongation data

Pageviews:

Hot rolled P295GH material standard steel coil and plates are among our main products. Hot rolling can significantly reduce energy consumption and cost. During hot rolling, the metal has high plasticity and low deformation resistance, which greatly reduces the energy consumption of metal deformation. Hot rolling can improve the p295gh material standard processing properties of metals and alloys, that is, the coarse grains in the casting state are broken, cracks are obviously healed, casting defects are reduced or eliminated, the as cast structure is transformed into deformed structure, and the processing properties of alloys are improved.

Our company has a comfortable office environment, covers a large area, can accommodate hundreds of people working at the same time. All kinds of green plants are placed in the company, with a healthy office environment. Our company also has gym, table tennis, leisure bar, kitchen, refrigerator, microwave oven and other equipment. Humanized construction provides comfortable office environment for employees.

After the steel plate is produced from the original factory, it will pass through a series of transportation and storage links and then be delivered to the processing workshop. During this period of time, the steel plate surface will contact with the air continuously, which will inevitably produce a layer of oxide skin. The oxide skin is a difficulty in the treatment process. It has high melting point, is not easy to burn and dissolve, increases preheating time, reduces cutting speed. Therefore, the surface of the p295gh material standard plate should be derusted before cutting.

SA516Gr60 material, SA516Gr70, SA516Gr60N, SA516Gr70N steel plate in thickness ≤1.5in (40mm) is usually supplied in rolled state. The plate can also be ordered according to normalizing or stress relief, or normalizing plus stress relief. SA516Gr60 steel plate when thickness> 1.5in. (40mm) should be normalized. Unless otherwise specified by the customer, p295gh material standard, SA516Gr60 steel plate (thickness ≤40mm) should be normalized when there is a notch toughness requirement.