en 10028-2 p265gh equivalent astm specifications

Pageviews:

30CrMnTi steel has higher strength and hardenability than 20CrMnTi steel, but its impact toughness is slightly lower. Mainly used as carburizing steel, it can be quenched directly after carburizing, with high bending strength and good wear resistance. It can be used after quenching, low temperature tempering or quenching and tempering, with medium machinability. 30CrMnTi steel can be used in the manufacture of heavy-duty carburized parts with large cross-sections and gears, gear shafts, worms, etc. with large forces in the tractor industry.

The company was established in 2000, covering an area of more than 4,500 acres. It has fixed assets of 200 million yuan, and employs more than 1,200 people. It has now formed coking, sintering, white ash, pellets, ironmaking, en 10028-2 P265GH equivalent astm steelmaking, steel rolling, oxygen production, gas and waste heat The complete circular economy industrial chain including power generation, comprehensive utilization of slag, soot and dust treatment, sewage treatment and recycling, etc. It mainly produces hot-rolled steel plates and en 10028-2 p265gh equivalent astm carbon structural steels, high-quality carbon structural steels, low-alloy high-strength steels, medium and wide-band steels for cold-rolled stamping, and hot-rolled coils.

The blanking of the structural steel plate is first to find 90 degrees, and then use a tape measure and a powder line to draw the cutting range. According to the thickness of the carbon steel plate plus the cutting allowance, drilling is required. For the deep processing of en 10028-2 p265gh equivalent astm structural steel sections or profiles: First use a square ruler or a curved ruler to find 90 degrees, and then use a square ruler or a ruler to cut the line and add the cutting margin to the hole.

"The production method of seamless steel pipe can be roughly divided into cross rolling method (menesmann method) and extrusion method. The cross rolling method (menesmann method) is to pierce the tube blank with the cross roll first, and then extend it with the rolling mill. This method is fast in production, but requires high machinability of tube blank. It is mainly suitable for producing carbon steel and low alloy steel tube, en 10028-2 p265gh equivalent astm tube.The extrusion method is to pierce the billet or ingot with a piercer, and then extrude it into a steel tube with an extruder. This method is less efficient than the cross rolling method and is suitable for the production of high-strength alloy steel tubes."

Respect customers and treat each other sincerely. Customers are always right. Always remember that the user is the God of the enterprise, respect the customer, and accept the customer's opinion modestly is the guarantee of the long-term development of the enterprise. Adhere to this concept, so that the service and the product are the same, long-term.