en 10028-2 p265gh H beams

Pageviews:

The method of distinguishing manganese plate from common carbon steel plate, en 10028-2 P265GH is as follows:(1) Check the spray labelWhether it is manganese plate or common carbon steel plate, it has its own factory spray mark, just check it;(2)Listen to the cutting soundThe cutting sound of manganese plate is relatively clear and crisp, while that of common carbon steel plate is not clear and crisp, and the manganese plate will fall off as soon as it is cut;(3) Look at the polishing sparksLook at the amount of sparks on the surface during polishing. The more sparks and forks are manganese plates, and the lesser ones are common carbon steel plates;(4) Check the material certificateGenerally, the material certificate will clearly indicate what material it is, just check it.

Compared with carbon steel, low alloy steel has many advantages, such as high strength, good plasticity and toughness, good weldability, good cold and hot pressure processing performance, better corrosion resistance, etc. Due to the increase of en 10028-2 p265gh metal composition, the yield point of low alloy steel structure is higher than that of ordinary carbon steel, so it is light and suitable for structural parts application. The low alloy steel is one of our main products.

Flame cutting is a common hot cutting method in modern iron and steel industry. It is also a very important part in the process of iron and en 10028-2 p265gh steel processing. Flame cutting can cut very thick carbon steel, its cutting range is very wide, can cut 6mm-200mm thick steel plate. In cutting thick and en 10028-2 p265gh medium plates, flame cutting plays an important role. And with its price advantage, flame cutting has always occupied a certain market share in thin plate cutting also.

Our company has been established for 20 years and has accumulated rich experience in steel products. At the same time, it is often exported to Southeast Asia, Africa, South America and other countries. So you can rest assured that our en 10028-2 p265gh products and our prices are very favorable. Because we have our own factory, there is no other cost, we can also carry out machining and so on.

After the order is finished, our after-sales service center will send an email to make a feedback about our steel products' quality. We have phone service every three months to remind our customers of the possible problems and collect advices or suggestions in quality and service. Upon the collection of advices or suggestions, our after-sales service will quickly make technical solutions to wipe out the customer problem.