en 10028-2 p265gh heat treatment processing

Pageviews:

The difference between cold rolled steel sheet and hot rolled steel plate. The carbon content of en 10028-2 P265GH, hot rolled steel plate is slightly higher than that of cold rolled steel sheet. In the case of little difference in composition, the density of cold rolled steel sheet and hot rolled steel plate is the same. Hot rolled steel plate has characteristics of low hardness, easy processing and good ductility. Cold rolled steel sheet has high hardness, and it is relatively difficult for processing. But it is not easy to deform and has high strength. Hot rolled steel plate can be made into alloy steel plate by adding other elements, and its properties are also excellent compared with other high-quality steel plates.

Keep in mind your mission and never forget your mission." At present, the BEBON steel leadership team unites the majority of cadres and employees to keep in mind their glorious missions, guided by Xi Jinping's ideology of socialism with Chinese characteristics in the new era, fully implementing the spirit of the 19th CPC National Congress, in-depth implementation of the requirements of the "three advances", pioneering spirit, and striving In order to lead high-quality development with innovation, build a new pattern of Anshan Iron and Steel's revitalization and development, strive to build the most internationally influential steel company, and make new contributions to the start of a new journey for BEBON Iron and Steel Group.

Many people will mix strip steel and steel plate together, which can usually be distinguished from the following points. First of all, the thickness of the steel plate is much thicker, and the thinner the strip steel is required, the better. Secondly, in appearance, the steel strip can be crimped and the steel plate is too thick to bend, even if it is bent, it is difficult to recover, because it is easy to break if it is bent too much. Thirdly, the strength of en 10028-2 p265gh, steel plate is higher than that of strip steel. The steel plate is suitable for construction engineering, while strip steel is only suitable for processing into hardware products.

The effect of nitrogen (N) on the properties of en 10028-2 p265gh and so on steel is similar to that of carbon and phosphorus. With the increase of nitrogen content, the strength of steel can be significantly improved, especially the plasticity, especially toughness, and the weldability will be decreased, and the cold brittleness will be intensified. At the same time, aging tendency, cold brittleness and hot brittleness will be increased, which will damage the weldability and cold bending property of steel. Therefore, the nitrogen content in en 10028-2 p265gh and so on steel should be reduced and limited as much as possible. Generally, nitrogen content should not be higher than 0.018%.