p295gh en 10028-2 suppliers with certificates

Pageviews:

P295GH en 10028-2, Weathering steel plate is a common material in the industrial field, such as some bridge construction, highway and railway construction and automobile manufacturing, you can see the application of weathering steel plate. At the same time, the performance characteristics of weathering steel plates are relatively good, and the variability is also a major feature worthy of praise.

With the development of China's p295gh en 10028-2 market economy, the company vigorously implements the strategy of industrialization, internationalization and diversification, promotes group operation, intensive development and lean management, and builds the company into a company with scientific development concept, continuous innovation vitality, excellent corporate culture and strong sense of social responsibility through rich series of p295gh en 10028-2 products and project portfolio and complete operation network And international first-class competitiveness of modern enterprises.

As the thickness and hardness of p295gh en 10028-2 increase, the tendency to crack at the cutting edge increases. In order to prevent the p295gh en 10028-2 from cutting cracks, preheating should be carried out before p295gh en 10028-2 cutting. Special attention should be paid to preheating to make the entire p295gh en 10028-2 interface evenly heated to avoid local overheating in the area contacting the heat source. If the whole p295gh en 10028-2 cannot be preheated, the partial preheating method can be used instead.

Laser cutting is that the horizontal laser beam emitted by the laser changes into a vertical downward laser beam through the 45° total reflector, and then focuses through the lens, forming a tiny spot at the focal point. When the spot hits the material, the material is heated to the vaporization temperature quickly, and evaporates to form a hole. With the movement of the beam on the material such as p295gh en 10028-2, the auxiliary gas (carbon dioxide gas, oxygen, Nitrogen, etc.) blow away the melted slag, make the hole continuously form a very narrow width (such as about 0.1mm) cutting seam, and complete the cutting of materials.

When providing technical services on site, the after-sales personnel shall strictly abide by the safety rules and regulations of the construction site, consciously take safety protection measures (such as wearing safety helmet when entering the construction site), accept the supervision and management of the site; without permission on the construction site, they shall not dismantle, smear or damage any goods; the commissioning of contract goods shall be carried out under the supervision of the site supervisor If necessary, it shall be approved by the site supervisor or the person in charge of the project department.